A Better Chain Grabber

0

Like most long-range cruising boats, Calypso is anchored on an all-chain rode. Deep water, windy anchorages and uncertain bottom conditions-including rope-eating coral heads-make chain the only really suitable rode if you want a good nights sleep.

Anchoring on chain, however, creates its own set of problems. The shock loads on an all-chain rode in extreme conditions can snap the chain, rip your windlass out of the deck, and wreak general havoc.

There are a variety of answers to the problem of preventing shock loading on a chain rode. The most common solution is a simple galvanized chain hook secured to a short length of nylon line, slipped over a link of chain, with the bitter end of line cleated off on deck. The chain is then eased out, so that the strain at the deck is taken on the line rather than the chain.

Like a lot of boats with high bows, Calypso tends to sail around on the anchor. On our mooring, we reduced this tendency by using a mooring bridle to cleats on either side of the stem, rather than a single line. For anchoring, we have found a similar solution-a better type of chain hook-that serves the same purpose.

Our improved chain grabber consists of a flat, heavy stainless steel plate, about 3-1/2″ by 4-1/2″. A slot cut into the plate slips over the chain, working just like a chain hook. In the corners of the plate, a pair of holes allow you to shackle in shock-absorbing nylon line. We have used 1/2″ three-strand nylon for the last six months, merely tied into the shackles. For a more permanent arrangement, I intend to splice 5/8″ three-strand nylon to stainless steel thimbles, which will be shackled to the plate. The thimbles will reduce chafe on the line, compared to the current method of securing the line with a bowline.

In the interim, I have just used conventional canvas chafing gear on the line, but when the finished version is made up, I will sew leather chafe protection onto the line where it passes through the hawse holes at the bow.

Using a bridle instead of a single line has the added advantage of reducing chain twist over time.

The grabber we have was made years ago by a long-gone company, but a virtually identical version is now available from ABI. Their figure 1044SS chain grabber is cast from type 316 stainless, rather than fabricated from plate. You supply the shackles and the line.

Unfortunately, this ABI product is rarely seen in stores or mail-order catalogs. You could probably get any marine store that deals with ABI-virtually all stores do-to special order for you. At a list price of $22, this is a cheap and effective piece of equipment.


Contact- ABI, 1160A Industrial Avenue, Petaluma, CA 94952; 707-765-6200, fax: 707-765-1716, e-mail: [email protected]

Darrell Nicholson
Practical Sailor has been independently testing and reporting on sailboats and sailing gear for more than 50 years. Its independent tests are carried out by experienced sailors and marine industry professionals dedicated to providing objective evaluation and reporting about boats, gear, and the skills required to cross oceans. Practical Sailor is edited by Darrell Nicholson, a long-time liveaboard sailor and trans-Pacific cruiser who has been director of Belvoir Media Group's marine division since 2005. He holds a U.S. Coast Guard 100-ton Master license, has logged tens of thousands of miles in three oceans, and has skippered everything from pilot boats to day charter cats. His weekly blog Inside Practical Sailor offers an inside look at current research and gear tests at Practical Sailor, while his award-winning column,"Rhumb Lines," tracks boating trends and reflects upon the sailing life. He sails a Sparkman & Stephens-designed Yankee 30 out of St. Petersburg, Florida. You can reach him at darrellnicholson.com.