![Corrosion Protection: Ethanol Fuel Additive Test](https://cdn.practical-sailor.com/wp-content/uploads/2019/10/samples.jpg)
Those boatowners preparing their gasoline-powered boats for winter storage will want to take a look at our gas additive test which compares the corrosion fight characteristics of such products as Biobor EB, Valv Tect, Sta-bil Marine Formula, Mercury QuickStor, Sea Foam and others. It is important to keep in mind that additives can’t solve real gasoline-quality problems. At best, consider additives to be only a final tweaking opportunity, something to supplement the following fuel-management practices.
Fresh fuel: Buy from the busiest fuel dock, preferably one that serves commercial users. A busy service station is good, too.
Eliminate outside water: Inspect your deck fill annually and replace the O-ring as needed. A silicon-based O-ring lubricant can help with sealing and prevent seizing. Make sure the vent wont admit water at any angle of heel.
![Corrosion Protection: Ethanol Fuel Additive Test](https://cdn.practical-sailor.com/wp-content/uploads/2019/10/jar.jpg)
Keep a full tank: This is absolutely vital with E-10, because of its potential to absorb water and its increased volatility, compared to conventional gasoline. Half-full tanks will breathe, allowing moisture into the tank. Some like to keep only the minimum amount of fuel on hand, in the false belief that they can keep the fuel fresh in this way, but this practice dramatically increases both humidity and oxygen exposure.
Use your engine: Many sailors pride themselves on running an engine for only a few minutes, just enough to clear the marina. The problem is, the engine never really warms up; it burns only a fraction of a gallon each trip, and the fuel stays in the tanks for a year or more. Ethanol gasoline simply isn’t formulated for that sort of storage life. While additives and a tight tank help, the chemicals themselves are not completely stable, and small tanks have a high ratio of fuel to oxygen exposure.
Fuel/water separators and oversize filters: These deliver valuable protection should you get a bad batch of gas, some water sneaks into your tank, or a sudden drop in temperature induces separation. They give you a means to drain the water while out on the water and get back home.
Beware of bad alloys: Avoid zinc or Zamak (a common zinc/aluminum/magnesium/copper die-casting alloy). These corrode rapidly in the presence of ethanol.
Use only ethanol-rated hose: Cheap fuel hoses may contain polymers that dissolve and deteriorate prematurely.
![Corrosion Protection: Ethanol Fuel Additive Test](https://cdn.practical-sailor.com/wp-content/uploads/2019/10/coupons.jpg)
For more on fuel additives and ethanol fuels, check out our 2008 test of ethanol fuel treatments, and our special report on ethanol fuels. If you are looking at replacing a diesel fuel tank on your boat, we have covered that too.